INDIAN
SUPPLIER
SUPPLIER
Harin Paints
Category - Chemicals
Harin Acrylic Paints are specially formulated, high performance acrylic emulsion based wall coatings for interiors.
Use of special light fast pigments, specialty additives and special acrylic resins in formulation of Harin Acrylic Paints ensures that they offer excellent long term protection against alkali, degradation, form a tough bond with the interior substrate prevent peeling, growth of fungus and algal for years.
Typical Properties
|
Appearance |
Smooth free flowing paste of uniform consistency |
|
Thinner |
Potable water |
|
Viscosity of supply at 30oC |
98 - 108 Krebs Units on Stormier viscometer |
|
Thinning Ratio |
75% by volume with water for each coat |
|
Method of application |
Brush, Roller or Spray |
|
Drying Time at 30oC, 65% R.H. |
Dry to touch 20 - 30 minutes |
|
Recoating period |
About 4 - 6 hours |
|
Coverage (on rough cement plaster) |
5.5 to 6.0 square meters per liter in two coats |
|
Finish |
Smooth, Matt. |
Uses
For application on RCC, Masonry, Concrete, Cement Plaster, Asbestos sheets and other similar surfaces.
How to use
Exterior performance of the products is critically dependent on adequate surface preparation and compliance of the application instructions as given below.
Surface Preparation
Newly plastered surfaces must be allowed to cure for at least 3 months before painting.
To ensure good adhesion, surface to be painted should be free dust. Grease and other loose materials. Any previous growth of moss, algal and fungi need to be removed thoroughly by vigorous wire brushing and cleaning with water. This treatment should be done with greater care on the top of the awnings, sunshades, parapets and other horizontal surfaces where water is likely to accumulate during rains.
Previously painted surface with oil paints should be sanded thoroughly to remove loose particles and made dull and matt for better adhesion. interior rough surface previously coated with cement paint should be wire brushed and washed with water thoroughly and allowed to dry. Ensure that the surface is free from chalking before painting.
Application of putty of filling compound should be avoided while painting on exterior surfaces. Cracks should be filled up using a cement and sand mixture in the ratio of 1:3.
Application
Apply two coats of Harin exterior Emulsion by thinning I Liter of paint with 450ml of water. However for freshly plastered surfaces apply oneself priming coat by thinning 1 liter paint with one little of water followed by two coats applied by thinning 1 liter paint with 450 ml. Water Apply 3 coats on horizontal surfaces for good results.
A gap of 4-6 hours should be given between the two coats.
